VeEX | FX41xT PON Terminated Power Meter, 1G/10G - 1490/1577nm with VFL | #Z06-99-255P
FX41xT PON Terminated Power Meter, 1G/10G - 1490/1577nm with VFL
Provides fast, simple, and precise measurement of G-PON and XGS-PON downstream signals. Miniature filters ensure each wavelength is measured accurately. The tester is well suited for installation, service verification, and troubleshooting of co-existent networks, including IEEE based E-PON and 10G-EPON deployments.
FEATURES
- Downstream signal verification for 1G/10G PON networks
- Simultaneous 1490/1577 nm signal level measurements
- Pass/Fail indication per ODN Class or User thresholds
- Alkaline or rechargeable NiMH batteries with Auto- off
- Save up to 2000 measurements with date and timestamp
- Save/display test results via NoApp® QR code for mobile device transfer, post-processing, sharing, and upload
- Cloud-based NoApp® service (included) allows for data augmentation via mobile phone or tablet. Secured and always up to date. No installation or updates required.
- Micro USB interface for 5V DC powering and battery charging
- High contrast backlit, monochrome display - visible outdoors and indoor with varying light conditions
- Splash and dust resistant keypad and chassis design
- Rugged polycarbonate chassis for demanding field conditions
- Fixed SC/APC connector interface with protective dust caps
- Visual Fault Locator (VFL) option
- Broadband Optical Power Meter (OPM) option
SPECIFICATIONS
- Wavelength-selective level measurements:
- G-PON per ITU-T G.984.2
- XGS-PON per ITU-T G.9807.1
- EPON & 10G-EPON per IEEE 802.3av
- Calibrated PON wavelengths (Downstream):
- 1490 nm (G-PON)
- 1577 nm (XGS-PON)
- Selective Spectral Passband
- Accurate measurements even in the presence of other wavelengths
- 1490 nm (1480 to 1500 nm)
- 1577 nm (1572 to 1582 nm)
- Display Resolution: 0.1 dB
- Absolute Accuracy: ± 0.5 dB
- Communication Interface: Contact-less QR codes
- Battery Charging Interface: Micro-USB
- Battery Operating Time: ≥ 75 hours (without backlight)
SPECIAL NOTICE:
Cleaning Instructions: Please be advised that these meters MUST be CLEANED before every job. EVERY Jumper needs to be cleaned before being inserted to the meter!
If proper cleaning is not followed, the meter will not work!!
REMINDER: If the meter stops working and it’s inspected, and they determine that it’s due to contamination (NOT PROPERLY CLEANED) IT WILL VOID THE WARRANTY AND REPAIRS WILL NOT BE COVERED UNDER THE WARRANTY.
WARRANTY INFORMATION